VIDENT iLink400 Software Update Guide

OBD360 will give you a step by step instruction on how to update software for VIDENT iLink400 in this post.
Note:
All iLink400 scan tool will be shipped without any Software installed. You can install any software from the following list at your choice by the update client iScanzilla.

Software Update
Step One- Install the Update Client
Visit www.videnttech.com to download the update client from
http://www.videnttech.com/support/

 


The file downloaded will be a compressed zip file. Open that file and run the installer inside it.
Alternatively, you can install the update client from the CD that comes in the product package.

Step Two – Create Your Vident Account.

Firstly you need to create an account with Vident.
Once installed, boots up the iScanzilla software, click the Register button.

Fill out the registration form and submit.

Alternatively, you can click the Sign Up button on the right upper side of our website to create an user account.

Step Three – Register Your product

When logged in iScanzilla, click the ‘Register Products’ icon.

On the ‘S/N Registration’ tab, put a tick in the box marked ‘001’ then enter the product’s serial number & password, and click Submit.
Please connect the scan tool with computer through the USB cable, select Setup > About to check the Serial Number and ‘Register Password”.

A confirmation box should be shown confirming successful registration.
Alternatively, you can register the product in the member center when logged in on our website.

Step Four – Download and Install Diagnostic Software
Now close the iScanzilla software, remove the TF card from your tool (making sure the tool is turned off first!) and connect it to the PC via a TF card reader.
Once Windows has detected the TF card, run the iScanzilla software and login again. After a few seconds, a list of the available software updates will appear.

Please select only one software you want to update, as you can ONLY have access to the update of this manufacturer in the future once it’s been selected initially. In case you want to install any other vehicle software, please contact
us or sign in your member center to purchase. Please refer to next chapter to buy extra software.
Click the Update button to download and install the software.

Once the software installed, you can go to Software Management to review the installed software.
Vident iLink400:
http://www.obd360.com/wholesale/vident-ilink400full-system-single-make-scan-tool.html