Procedure:
In the left rear of the car, open the plaque, see the fuse box, remove the fuse box and see the RAF smart computer
Connect Yanhua ACDP to OBP+ ICP adapter, then to BDM adapter, then to KVM adapter. Wait the indicator turn red then green.
Click on “LandRover” option.
Click on ” KVM (MC9S12XEQ384 112Pin)”.
Click on “IMMO”.
Come to the main menu:
MC9S12XEQ384_0M12S
MC9S12XEQ384_1M12S
MC9S12XEQ384_2M25J
MC9S12XEQ384_3M25J
Choose ” MC9S12XEQ384_3M25J”
Click on ” Add key auto mode”
Starting application.
Device connection succeed.
Note: Please prepare the OBP+ICP adapter, BDM adapter, KVM module, BAV adapter and Blank key.
Follow the tip to ensure the well connected for ACDP device, OBP +ICP adapter, BDM adapter and KVM module.
Detecting pins status, please wait..
Good contact and continue.
Configuring adapter, please wait…
It is detected the KVM module chip has been encrypted, whether to continue? click on “Continue”.
Configuring adapter, please wait…
Decrypting the chip, please wait… It will take several minutes.
Reading chip PFLASH data, please wait…
Please save the original PFLASH data of the KVM module.
Uploading data…
File save path.
Reading chip EEPROM /PFLASH data, please wait…
Please save the original EEPROM data of the KVM module.
Just click “Yes” until you see the immo info shown as below.
Just follow the on-screen instruction to do .
Please choose to add the keyway.
Choose key 6.
…
Just follow the on-screen instruction to operate.
One more time, it will show “Decrypting the chip, please wait… ” and it will take several minutes again.
Next is writing chip EEPROM /Plash data, please wait…
Checking chip data, please wait.
Adding the key complete. Please install the KVM module to the car and confirm that the new key can be used normally.
Done.
PS: just use the same way to program new key when all keys lost.
Article from:http://blog.obd360.com/how-does-acdp-read-write-jaguar-land-rover-kvm-data-via-icp/
